METAL MAGIC STAINLESS STEEL CLEANER
Chemwatch Independent Material Safety Data Sheet
Issue Date: 29-Jan-2010
METAL MAGIC STAINLESS STEEL CLEANER
Cleaner for stainless steel.
Company: Benji Distributors Pty Ltd Address: 17 Grandview Pde Moolap VIC, 3221 Australia Telephone: +61 3 5248 1469 Fax: +61 3 5248 6696
HAZARDOUS SUBSTANCE. NON-DANGEROUS GOODS. According to NOHSC Criteria, and ADG Code.
|SCALE: Min/Nil=0 Low=1 Moderate=2 High=3 Extreme=4|
|■ Harmful by inhalation.||■ Use only in well ventilated areas.|
|■ Irritating to skin.||■ Keep container in a well ventilated place.|
|■ Risk of serious damage to eyes.||■ Avoid exposure - obtain special instructions before use.|
|■ Possible risk of impaired fertility.||■ To clean the floor and all objects contaminated by this material, use water.|
|■ Ingestion may produce health damage*.||■ Keep away from food, drink and animal feeding stuffs.|
|■ Cumulative effects may result following exposure*.||■ If swallowed, IMMEDIATELY contact Doctor or Poisons Information Centre. (show this container or label).|
|* (limited evidence).|
|sodium perborate tetrahydrate||10486-00-7||1-10|
· Immediately give a glass of water.
· First aid is not generally required. If in doubt, contact a Poisons Information Centre or a doctor.
■ If this product comes in contact with the eyes:
· Wash out immediately with fresh running water.
· Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids by occasionally lifting the upper and lower lids.
· Seek medical attention without delay; if pain persists or recurs seek medical attention.
· Removal of contact lenses after an eye injury should only be undertaken by skilled personnel.
■ If skin contact occurs:
· Immediately remove all contaminated clothing, including footwear.
· Flush skin and hair with running water (and soap if available).
· Seek medical attention in event of irritation.
· If fumes or combustion products are inhaled remove from contaminated area.
· Other measures are usually unnecessary.
■ For acute or repeated short term exposures to boron and its compounds: · Nausea, vomiting, diarrhoea and epigastric pain, haematemesis and blue- green discolouration of both faeces and vomitus characterise adult boron intoxication. · Access and correct any abnormalities found in airway and circulation. · A tidal volume of 10- 15 mg/kg should be maintained. · Emesis should be induced unless the patient is in coma, is experiencing seizures or has lost the gag reflex. If any of these are present, gastric lavage should be performed with a large- bore tube after endotracheal intubation or in the presence of continuous respiratory action.
· There is no restriction on the type of extinguisher which may be used. · Use extinguishing media suitable for surrounding area.
· Alert Fire Brigade and tell them location and nature of hazard. · Wear breathing apparatus plus protective gloves for fire only. · Prevent, by any means available, spillage from entering drains or water courses. · Use fire fighting procedures suitable for surrounding area.
· Non combustible. · Not considered a significant fire risk, however containers may burn. Decomposition may produce toxic fumes of: sulfur oxides (SOx). May emit poisonous fumes. May emit corrosive fumes.
■ None known.
Gloves, boots (chemical resistant).
· Clean up all spills immediately. · Avoid breathing dust and contact with skin and eyes. · Wear protective clothing, gloves, safety glasses and dust respirator. · Use dry clean up procedures and avoid generating dust.
■ Moderate hazard. · CAUTION: Advise personnel in area. · Alert Emergency Services and tell them location and nature of hazard. · Control personal contact by wearing protective clothing. · Prevent, by any means available, spillage from entering drains or water courses.
Personal Protective Equipment advice is contained in Section 8 of the MSDS.
· Avoid all personal contact, including inhalation.
· Wear protective clothing when risk of exposure occurs.
· Use in a well-ventilated area.
· Prevent concentration in hollows and sumps.
· Lined metal can, lined metal pail/ can.
· Plastic pail.
· Polyliner drum.
· Packing as recommended by manufacturer.
· Polyethylene or polypropylene container.
· Check all containers are clearly labelled and free from leaks.
· Avoid strong bases.
· Store in original containers.
· Keep containers securely sealed.
· Store in a cool, dry area protected from environmental extremes.
· Store away from incompatible materials and foodstuff containers.
|• sulfamic acid:||CAS:5329-14-6|
|• sodium perborate tetrahydrate:||CAS:10486-00-7 CAS:11138-47-9 CAS:10332-33-9 CAS:7632-04-4 CAS:10042-94-1|
· Safety glasses with side shields. · Chemical goggles. · Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy document, describing the wearing of lens or restrictions on use, should be created for each workplace or task. This should include a review of lens absorption and adsorption for the class of chemicals in use and an account of injury experience. Medical and first- aid personnel should be trained in their removal and suitable equipment should be readily available. In the event of chemical exposure, begin eye irrigation immediately and remove contact lens as soon as practicable. Lens should be removed at the first signs of eye redness or irritation - lens should be removed in a clean environment only after workers have washed hands thoroughly. [CDC NIOSH Current Intelligence Bulletin 59].
· Wear chemical protective gloves, eg. PVC. · Wear safety footwear or safety gumboots, eg. Rubber.
· Overalls. · P.V.C. apron. · Barrier cream. · Skin cleansing cream.
· Local exhaust ventilation is required where solids are handled as powders or crystals; even when particulates are relatively large, a certain proportion will be powdered by mutual friction. · If in spite of local exhaust an adverse concentration of the substance in air could occur, respiratory protection should be considered. Such protection might consist of: (a): particle dust respirators, if necessary, combined with an absorption cartridge; (b): filter respirators with absorption cartridge or canister of the right type; (c): fresh- air hoods or masks. Air contaminants generated in the workplace possess varying " escape" velocities which, in turn, determine the " capture velocities" of fresh circulating air required to effectively remove the contaminant.
White powder; mixes with water.
Mixes with water.
|State||Divided Solid||Molecular Weight||Not Available|
|Melting Range (ºC)||Not Available||Viscosity||Not Available|
|Boiling Range (ºC)||Not Available||Solubility in water (g/L)||Miscible|
|Flash Point (ºC)||Not Applicable||pH (1% solution)||3.3-3.7|
|Decomposition Temp (ºC)||Not Available||pH (as supplied)||Not Available|
|Autoignition Temp (ºC)||Not Available||Vapour Pressure (kPa)||Not Available|
|Upper Explosive Limit (%)||Not Available||Specific Gravity (water=1)||Not Available|
|Lower Explosive Limit (%)||Not Available||Relative Vapour Density (air=1)||Not Available|
|Volatile Component (%vol)||Not Available||Evaporation Rate||Not Available|
· Presence of incompatible materials.
· Product is considered stable.
· Hazardous polymerisation will not occur.
For incompatible materials - refer to Section 7 - Handling and Storage.
|ACUTE HEALTH EFFECTS||CHRONIC HEALTH EFFECTS|
|■ Harmful by inhalation.||■ Possible risk of impaired fertility.|
|■ Irritating to skin.||■ Cumulative effects may result following exposure*.|
|■ Risk of serious damage to eyes.||■ * (limited evidence).|
|■ Ingestion may produce health damage*.|
|■ * (limited evidence).|
■ unless otherwise specified data extracted from RTECS - Register of Toxic Effects of Chemical Substances. ■ Not available. Refer to individual constituents. ■ Asthma- like symptoms may continue for months or even years after exposure to the material ceases. This may be due to a non- allergenic condition known as reactive airways dysfunction syndrome (RADS) which can occur following exposure to high levels of highly irritating compound. SULFAMIC ACID:
|Oral (rat) LD50: 3160 mg/kg||Skin (human): 4 %/5 days (I)- Mild|
|Skin (rabbit): 500 mg/24 h-SEVERE|
|Eye (rabbit): 250 ug/24 h - SEVERE|
|Eye (rabbit): 20 mg - Moderate|
|Oral (human) LDLo: 214 mg/kg||Eye(rabbit): 50 mg - Moderate|
|Oral (rat) LD50: 1200 mg/kg|
|Oral (Human) LD: 214 mg/kg|
|Oral (Human) LD: 250 mg/kg|
|Oral (Human) LD: 400 mg/kg|
|Oral (Mouse) LD50: 1060 mg/kg|
|Intraperitoneal (Mouse) LD50: 538 mg/kg|
|Ingredient||Persistence: Water/Soil||Persistence: Air||Bioaccumulation||Mobility|
· Containers may still present a chemical hazard/ danger when empty.
· Return to supplier for reuse/ recycling if possible.
· If container can not be cleaned sufficiently well to ensure that residuals do not remain or if the container cannot be used to store the same product, then puncture containers, to prevent re-use, and bury at an authorised landfill.
· Where possible retain label warnings and MSDS and observe all notices pertaining to the product.
· Recycle wherever possible.
· Consult manufacturer for recycling options or consult local or regional waste management authority for disposal if no suitable treatment or disposal facility can be identified.
· Dispose of by: burial in a land-fill specifically licenced to accept chemical and / or pharmaceutical wastes or Incineration in a licenced apparatus (after admixture with suitable combustible material)
· Decontaminate empty containers. Observe all label safeguards until containers are cleaned and destroyed.
None (ADG7) NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS: ADG7, UN, IATA, IMDG
POISONS SCHEDULE None
Regulations for ingredients
"Australia Hazardous Substances","Australia Inventory of Chemical Substances (AICS)","Australia Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) - Appendix E (Part 2)","Australia Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) - Appendix F (Part 3)","Australia Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) - Schedule 5","Australia Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) - Schedule 6","International Council of Chemical Associations (ICCA) - High Production Volume List","OECD Representative List of High Production Volume (HPV) Chemicals"
"Australia Inventory of Chemical Substances (AICS)","Australia Therapeutic Goods Administration (TGA) Substances that may be used as active ingredients in Listed medicines"
|sodium perborate tetrahydrate||10486-00-7, 11138-47-9, 10332-33-9, 7632-04-4, 10042-94-1|
17 Grandview Parade
■ Classification of the preparation and its individual components has drawn on official and authoritative sources as well as independent review by the Chemwatch Classification committee using available literature references.
A list of reference resources used to assist the committee may be found at:
■ The (M)SDS is a Hazard Communication tool and should be used to assist in the Risk Assessment. Many factors determine whether the reported Hazards are Risks in the workplace or other settings.
This document is copyright. Apart from any fair dealing for the purposes of private study, research, review or
criticism, as permitted under the Copyright Act, no part may be reproduced by any process without written
permission from CHEMWATCH. TEL (+61 3) 9572 4700.
Issue Date: 29-Jan-2010
Print Date: 15-Nov-2010
This is the end of the MSDS.